Description
Caterpillar C13 ADEM 4 control module | LEE | 120 Pins
The Caterpillar C13 ADEM 4 control module arrives tested, programmed and ready to work. First, our bench team reads the engine serial number you send us. Then we load the correct file for your C13 engine.
As a result, the unit installs as plug and play in the exact vehicle or machine. In addition, every order leaves our shop in Orlando, Florida.
Part numbers and references
- 223-1235
- 10R4094
- Engine serial prefix LEE
- 120-pin diesel ECM housing
Two references describe the same unit. Therefore, check the label on your old module before you order. Also, send a photo of the connector if you have any doubt.
What the Caterpillar C13 ADEM 4 control module does
This ADEM IV board drives the injectors and reads every engine sensor. Moreover, it stores the fault codes your technician pulls during diagnosis.
Because the software must match the engine, we never ship a blank board. For example, a truck file will not run a generator set. Therefore, we confirm the application before we program anything. Programming is included in the price.
Symptoms that point to a failed module
Many engines reach us with the same complaints. For example, the engine shuts down without warning. Sometimes the diagnostic tool loses communication with the controller.
In addition, fuses blow as soon as the key turns. A failing Caterpillar C13 ADEM 4 control module often shows more than one symptom. Moreover, oil or water intrusion damages the board over time.
What to send with your order
Send us the engine serial number before we program the unit. First, note the machine or truck model. Then add the fault codes your technician reads on site.
Moreover, tell us how the failure appears during work. For example, some engines only stall when they warm up. As a result, our bench can reproduce the same condition.
Before you install this module
We program each unit from scratch against the serial number you provide. However, we cannot promise a plug and play result on every machine.
Some Caterpillar equipment needs extra configuration on site. Therefore, a certified Caterpillar technician should fit it with original diagnostic software. Finally, that technician completes any machine specific setup during the installation.
Warranty and technical support
Every unit carries a one year warranty. Also, our team answers technical questions before and after the sale. For example, you can describe the fault codes you read today.
Why trust our bench
Our engineering team carries more than 15 years of experience. Furthermore, we have rebuilt over 10,000 modules to date. Our simulation equipment reproduces the real engine signals during testing.
Order your Caterpillar C13 ADEM 4 control module
Ready to move forward? First, read our ECM repair services process. Next, browse the full Caterpillar C13 ECM range. Finally, watch real bench tests on the ECM Engineering USA YouTube channel.
