Description
Caterpillar marine ECM repair service | C15 ADEM IV | 120 Pins
Our Caterpillar marine ECM repair service returns your module fully reconditioned and tested. First, you ship the unit to our shop in Orlando, Florida. Then our engineers diagnose every fault on the board.
After that, we rebuild the failed sections and test under load. As a result, the module goes back in the same marine engine. Moreover, you save the time and cost of programming a new ECM for your boat.

Part numbers covered by this service
- 478-7932 and 4787932
- 20R-8181 and 20R8181
- 11R-0332 and 11R0332
- 303-2383-00 and 303238300
- 329-8538, 3298538 and 3298538-00
- 255-5287-02, 2555287 and 255528702
Several references describe the same controller. Therefore, check the label on your module before you ship it. Also, send a photo of the connector if you have any doubt.

Engines covered by our Caterpillar marine ECM repair service
This ADEM IV housing serves the CAT C15 marine engine with 120 pins. In addition, the same family appears in other Caterpillar marine packages. However, serial ranges matter, so send your engine serial with the unit.

Common faults we fix
- Blowing fuses
- No communication with the diagnostic tool
- Engine shutting down
- Fault codes stored in the unit
- Intermittent faults under vibration
- Oil intrusion
- Water damage
However, many units arrive with more than one symptom. Consequently, we test every circuit before we close the housing.
Why marine modules fail on board
Salt air and constant vibration work against every board. First, the solder joints crack after thousands of hours. Then moisture reaches the tracks through a tired seal.
In addition, a weak alternator sends spikes into the supply rails. As a result, the injector drivers fail one by one. Therefore, we check the charging data before we return the unit.
How our bench tests the board
First, we open the housing and inspect the tracks under magnification. Then we measure the supply rails and the injector drivers.
Next, we replace the components that fail the test. After that, the board runs a full cycle on our simulator. As a result, an intermittent fault shows up before the unit leaves.
How the Caterpillar marine ECM repair service works and what it costs
You only need to ship your unit to us. Then we diagnose it and report what we find. However, if the module is not repairable, or if no problem appears, the diagnostic cost is 200 dollars. In that case, we process a partial refund for the difference.
Warranty and technical support
A one year warranty backs every repair we deliver. Also, our team answers technical questions before and after the job. For example, you can describe the fault codes you read today.
Why trust our bench
Our engineering team carries more than 15 years of experience. Furthermore, we have rebuilt over 10,000 modules to date. Our simulation equipment reproduces the real engine signals during testing.
Order your Caterpillar marine ECM repair service
Ready to start? First, read our ECM repair services process. Next, browse the full Caterpillar ECM range. Finally, watch real bench tests on the ECM Engineering USA YouTube channel.



